Racelogic VBOX User Manual - Logging Modes
VIDEO VBOX MANUAL
Page | 9
20 October 2010
Getting Started with your Video VBOX
Logging Modes
The Blue LED will come on when the unit is recording video, this LED will flash when the unit is closing the file.
DO
NOT REMOVE
the SD card if the Record LED is on or is flashing.
The Video VBOX has two modes:
Log only when moving (default)
The unit automatically starts logging data when the vehicle speed goes above 2.5km/h, and stops when it goes below
this value. This speed is configurable, see ‘Scene propeties’. Pressing the REC button will stop the recording and close
the file.
Manual logging
By pressing the REC button on the front of the unit, the user may override the Automatic logging function. The unit
will then record until the card is full, the power is removed, or until the user presses the REC button once more.
Note : to prevent potential loss of video, the unit will revert back to automatic logging if the car then starts to move
again, or if the SD card is changed.
LED functions – PRO 4 CAM
LED
COLOUR
INDICATES
PWR
Red
Power on
CAMERAS 1,2,3 & 4
Green
A camera is connected
DATA C
Red
Correctly connected to a device and
receiving CAN signals. Note, must be
configured to receive in VVB setup
software.
DATA S
Green
Recognised serial information is
being received. E.g. From a
connected DriftBox
USB
Red
USB logging media is connected
GPS
Red / Green
i) Red indicates no satellite lock held
ii) Green indicates SAT lock achieved
MEMORY
Red
i) Amount of memory used in the
attached logging media
(incrementing sequence)
ii) Status of scene upload or
firmware upgrade (incrementing
sequence)
iii) Searching for media
(in/out sequence)
REC
Blue
Data being recorded to media.