RAD V-RAD User Manual - page 5
Operating Instructions
4. OPERATION
Your new V-RAD tool will come with a torque chart as seen in Figure 1.1 affixed to the gear box of the
tool. The torque chart displays alpha and numeric characters that are dialed in on the tool that correspond
to the torque values to the right. To select a desired torque, dial in your V-RAD by using the alpha and
numeric selections on top of the V-RAD gun Figure 1.2. For example, for preset (G6) dial the alpha dial so
that the black arrow underneath is pointing at the (G) and dial the numeric dial so that the arrow on top
is pointing at the (6).
Do not attempt to run the tool with settings that are not displayed on the torque chart. Failure to do so
could cause the tool to fail and void your warranty.
(Figure 1.1) (Figure 1.2)
V-RAD 1000 Torque Chart (ft.lbs.)
Setting
Torque
Setting
Torque
B2
320
E3
750
C2
350
F3
800
E2
450
G3
830
F2
500
D4
850
G2
530
E4
900
C3
550
C5
930
D3
620
F4
960
G4
1020
Cal.Date 22/03/2006
Serial # Demo
Sample Torque Chart
4
070606