RAD V-RAD User Manual - page 6
Operating Instructions
4. OPERATION
(continued)
•
To switch your V-RAD into forward and reverse, move the switch in the direction of the arrow that is
shown in Figure 1.3
•
On the top of the V-RAD there will be a selector switch (shown in Figure 1.4) that will show a picture
of a drill bit on the left side.
This is correct position for this switch
If the switch is moved to the left
and a picture of a hammer is shown on the right, the gun is set improperly.
•
On the handle of your V-RAD there will be a small button (shown in Figure 1.5) that is used as a trig-
ger locking mechanism and has been locked out for your safety.
Do not try to push this button in and
enable this mechanism—it will put the user at risk of injury.
5. ACCESSORIES
•
Use original RAD accessories only.
•
To assist in selecting the correct accessories, make sure that you take a note of the exact model of your
tool and contact your RAD dealer.
6. REPAIRS
•
Repairs to tools should only be carried out by a qualified RAD Service Technician and if otherwise
warranty of tool will be void.
•
Any RAD power tool in need of repair can be sent to the address below. Please attach a description of
the fault to the tool.
(Figure 1.3)
(Figure 1.4)
(Figure 1.5)
5
070606