Radial Engineering Phazer Owner's Manual - page 6
Tip = Send
Ring = Return
Sleeve = Common
Send
Return
4
insert cable like the one shown here.
b. Balanced Inserts on Separate Jacks (+4dB): Balanced connec-
tion may be accomplished with either XLR or TRS Phone jacks with
the proper interface cables: See chart for balanced wire confi guration.
CONNECTIONS
Before making connections turn your monitors or PA system off.
Power: The Phazer is powered by a 15VDC/400mA supply (in-
cluded). Do not substitute with another power supply. If you need a
replacement please contact your dealer (see the power supply part
numbers on the specifi cations page for your region). The Phazer's
power connection includes a cable lock feature.
Audio: The Phazer is a line-level device that accepts +4dB bal-
anced and -10dB unbalanced signals at either the XLR or ¼”
phone jacks. Balanced connections use the AES standard (pin-2
hot). There are two basic methods for connecting the Phazer:
1. Console Insert Connection - This is the most common connec-
tion. The Phazer is placed in the signal path using the "insert" point
at the console (or studio patchbay). Determine the type of insert
points your console is equipped with.
a. Unbalanced Single-Point Insert (-10dB): Requires a single point
Use a hex driver to
loosen the cable lock.
Pass the cable through
and re-tighten.
Radial Engineering
Phazer & Phazer-Bank
XLR
TRS Phone
Pin 1
Common
Sleeve
Pin 2
Hot (+)
Tip
Pin 3
Cold (-)
Ring
True to the Music