Hardware user’s manual digital video motion detector dvmd14 june, 2013 radiant, inc. 2395 kenwood drive boulder, co 80305 phone: (303) 543-0440 fax: (303) 543-2126.
Introduction this is a manual for the installation, setup, and configuration of the dvmd14. It contains step-by-step instructions for connecting the dvmd14 in a system. It outlines a variety of set-up features. Please also refer to the xport user manual to change the ip address and local port number...
Product: dvmd14 part number: 800-000 physical 2u chassis with 19” rack mounting tabs. Weight: 14 pounds (including 14 modules) black powder coat finish on metal chassis. Video processor installation the expanded area of the chassis shows a single video processor installed in slot “0” at address ff0....
Product: video processor part number: 800-002 note: 1 to 14 video processors may be installed. A video processor may be installed in each of the 14 slots of the dvmd14 backplane. Each video processor contains an embedded digital signal processor (dsp) that executes our proprietary digital video moti...
Connection to host pc each dvmd14 may be connected to a host pc nic card using a “reverse cat5” cable, or to a hub or router with a “straight-through cat5” cable. The pc will run the managernetxxx.Exe program, establish a network connection to the dvmd14 and allow changes. A security system with mor...
Ptz connections four screw terminals provide connection to rs422 type pan tilt zoom (ptz) cameras. Two wires are for do+ and do-, and two wires are for di+ and di-. Shield may be used to keep the common mode voltage of the camera and the dvmd14 transceivers within the +12 to -7v range. If shield is ...
• step seven: power up the camera and the cctv monitor. You should get a video picture with overlay on the monitor. If you do not get a picture on the monitor re-check steps 1 – 6 above. If you do get a video image on the monitor, proceed with loading the user interface software as described in the ...
