Radiant DVMD14 User Manual - page 7
•
Step Seven:
Power up the camera and the CCTV monitor. You should get a video picture with overlay on the
monitor. If you do not get a picture on the monitor re-check Steps 1 – 6 above. If you do get a video
image on the monitor, proceed with loading the User Interface Software as described in the User
Interface – Manager Tools Window paragraph below.
•
Step Eight (Optional PTZ Support)
Connect a PTZ camera to the desired channel using the RS422 connections. The DVMD14 DO+ and
DO- pair should be connected to the DI+ and DI- pair of the PTZ camera.
User Interface – Software
The DVMD14 is configured with a Windows Graphical User Interface that is available as a download from the
Radiant website. ManagerNETxxx.zip contains several Windows programs that may be used with the DVMD14.
The main program is ManagerNETxxx.exe, which configures the cameras and provides the user interface to the
DVMD14. The user MUST use the version of Firmware in the Video Processor that matches the version of
ManagerNET. These programs are zipped together to avoid mis-matched versions. The zip file also contains the
corresponding documentation for the software. Other programs included in the ZIP file such as MangerNETxxx,
Manager, ServerNET, PTZnet, APInet and UpgradePAK are all matched to each release.
Please refer to the DVMD14 Software User’s Manual for further information. Download ManagerNETxxx.zip at
www.dvmd.com
in the “SUPPORT” tab on the right panel.
DVMD14
The DVMD14 replaced the DVMD16 product in 2009. This product has two power supplies to satisfy the
redundant power requirements in oil/gas and nuclear industries. To make room in the chassis for the extra
supply two of the video channels were removed.
All 14 chassis have video bypass relays on each channel for new products shipped with Revision “F” backplanes
and greater. These relays allow the video to pass through the chassis un-altered when the power is “off” on both
supplies.
XPORT User Manual
Please also refer to the XPORT User Manual to change the IP address and Local Port number for each DVMD1-
X.