Radiant V4400 User Manual - page 11
Appendix B: Console Menu Configuration
1. There are two ways to connect to the Console Menu System in the V4410.
a) If the IP address of the V4410 unit is known, and your PC is on a network reachable by the unit
V4410, then you can simply telnet into the V4410. From Windows 2000/XP click on the start menu,
and then the Run…dialog box. Enter the command telnet 192.168.1.84, where you will replace
192.168.1.84 with the actual IP address of the V4410 unit.
Once connected to the unit you will be prompted for a username and password before you can access the
menu. (Note: default username/password is admin/admin, also there is known bug in the implementation of
Microsoft’s XP telnet application, after entering the username you will notice a dead character before you
type the password. To get around this you will need to insert an extra junk character for each line of
communication with the menu, after the username is entered, or use any other telnet program)
b) If you do not know anything about the V4410, then a serial connection is most likely the easiest way
to perform your initial configuration. Use the serial null modem cable supplied with your unit, and
connect one end to the V4410, and the other to one of the communications ports on your Windows
2000/XP PC. You will then want to launch Microsoft’s HyperTerminal application, which will allow
you to communicate with the V4410 through your PC’s serial communications port. If you do not
have HyperTerminal installed, go to the control panel, add/remove settings, add/remove windows
components, and install it from there. To launch HyperTerminal go to the start menu, select
Programs>Accessories>Communications>HyperTerminal.
11