Radiant V4400 User Manual - page 4
4
V4410 Set-up
Hardware Installation
1. Connect the video source to either the BNC Video connector (for composite video) or the S-
Video connector.
2. Connect your Lan Ethernet cable to the Ethernet RJ-45.
Note: Link and Activity Leds
indicate 100Mb and Full Duplex Respectively
3. Power up the unit using the AC line cord.
4. Connect Audio source to the 1/8
th
inch Audio Connector using the RCA-to-1/8”Adapter
provided.
.
Configuring the V4410
Before you can use the V4410 on your network, you will need to determine whether or not to assign a static
IP Address to your V4410 (which means that it retain same the IP Address until you change it), or use the
default DHCP setting that allows your network to automatically assign a dynamic IP address. It is
recommended that you assign a static IP Address to your V4410.
1. In order to configure your V4410, you will need to ask your IT/Networking department for the
following information:
a. Does your network use DHCP and have a DHCP Server running? (Yes or No. If No, you will need
to assign a static IP Address to your V4410.)
b. What is the subnet mask of your network? (Example: 255.255.255.0)
c. What is the default gateway address on your network? (Example: 192.168.1.1)
d. What is an available IP address we can assign to the V4410 unit? (Example:
192.168.1.100)
2. Connect the Null Modem cable between the RS-232 port of the V4410 and a COMM port on your PC
(typically the COM1 port).
3. Launch Microsoft’s HyperTerminal application. [If you do not have HyperTerminal installed, go to the
Windows Control Panel> Add or Remove Programs> Add/Remove Windows Components, and install it
from there.]
a. Go to the Windows Start menu, select Programs> Accessories> Communications> Hyper-
Terminal.