Radient Duplex Duplex RDNA0397 Owner's manual - page 5
Specifications
FOREWORD
Operating voltage range:
DC 11.0~18.0 Volt
AC 100V-240V
Circuit power:
Maximum charge power 50W x 2
Maximum discharge power 5W x 2
Charge current range:
0.1A-5.0A x 2
Discharge current range:
0.1A-1.0A x 2
Current drain for balancing Li-po:
Max 250mAh/cell
NiCd/NiMH battery cell count:
1~15 cell x 2
Li-ion/Polymer cell count:
1~6 cell x 2
Pb battery voltage:
2V~20V x 2
Weight:
760g (Net Weight)
Dimensions:
192 x 146 x 42mm
Thank you purchasing the Duplex dual output, 50W per channel Balance
Charger/Discharger. This product is a rapid charger with a high performance
microprocessor and specialized operating software. Please read and understand this
entire operating manual before using this product, as it covers a wide range of
information on both the operation of the Duplex charger and safety. If in any doubt,
please seek the help of an experienced user, contact support or contact the dealer
where you purchased your product.
• Before using the Duplex charger, review all documentation and inspect the product
carefully. If for some reason you decide it is not what you wanted, then do not continue
with unpacking, setup or operation of your product. Your local hobby dealer cannot
accept a product for return or exchange if the product or packaging shows signs of
wear and tear.
• Product specifications are subject to change without notice. Due to ongoing
development, the actual product may vary from images shown.
• This product contains chemicals known to the State of California to cause cancer and
birth defects or other reproductive harm.
• This product is not a toy! (14+) Recommended for ages 14 and up. Adult supervision
required for age s under 18 years old. Contains small parts, keep out of reach of
children 3 years of age and younger.
Warnings and error information continued
The Duplex incorporates a variety of safety functions that verify the processes and
electronics. In the event of an error occuring, the screen will display the cause and
emit a warning sound.
The internal temperature is too high. Allow the charger to
cool.
The processor cannot control the current required by the
process
The charger has not been able to accurately detect the
voltage of the battery. Please check the connector & leads.
3
26