Radio Systems, Inc.
CT-2002 Manual
Page 13
RESET
STOP
START
CLOCK
TIMER
CLOCK SET
PROGRAM
1
2
3
4
5
6
7
8
9
0
MEM 1
MEM 2
MEM 3
MEM 4
MEM 5
MEM 6
Storing Down Times
1. Press the Timer Button.
The Timer LED will illuminate.
2. Using the numeric keypad, enter a down
time. The Set LED and Down LED will illumi-
nate. Hours may be from 00 to 99, minutes
from 00 to 59, and seconds from 00 to 59.
Erroneous entries can be overwritten or the
Reset button can be used to zero the display.
3. Press one of the Store Buttons. If the time
entered was valid, the display will momen-
tarily flash, the Set LED will extinguish and
the down time will be stored. In addition, the
entered down time will remain on the display
and the Down LED will remain illuminated.
However, an invalid time (such as 12:60:00)
will be cleared when a Store Button is
pressed. In addition, the CT-2002 will return
to the Up Timer Mode.
4. Repeat steps 2 and 3 as desired.
Recalling Stored Down Times
1. Press the Timer Button.
The Timer LED will illuminate.
2. Press one of the Store Buttons.
3. The stored down time will appear on the
display. The Down LED will illuminate.
4. Press the Start Button to begin down timing.
5. Press the Stop Button to stop down timing.
6. Press the Start Button to resume down timing.
7. Press the Reset Button once to recall the
selected down time. Repeat steps 3 through 6
as desired.
8. Press the Reset Button two times to exit the
down mode (return to up timing mode) and
clear the display
Note: Stored Down-Time 1 can be recalled
remotely via parallel remote control wiring.
See illustration page 18.
Push to display
Time-of-Day
Push to freeze
Timer Display
When Up-Timing:
Push.once.to.reset.timing.to.00:00..
(Continues.to.run.if.reset.from.Stop)..
(Holds.if.reset.from.Stop)
When Down-Timing:
Push.once.to.redisplay.down.time..
Push.again.to.return.display.to.00:00..
and.Up-Time.mode.
In Clock Mode:
Starts.display.running.from..
Time-of-Day.set.mode
In Timer Mode:
Starts.display.running.from..
Up.or.Down.Timer.display.
Push for Timer Mode
Push to set Time-of-Day
. Enter.via.numeric.keypad.
. Push.start.
Push to set Internal Programming fea-
tures (see setup functions on page 10).
.
Program.functions.via..
.
numeric.keypad.
.
Push.Timer.or.Clock.to.exit..
.
in.that.mode
To set down time
.
Enter.time.via.numeric.keypad.
.
Push.start.to.begin.
.
Push.reset.to.recall.downtime.
.
Push.reset.2x.to.exit.
CT-2002 InfraRed Remote Control
MEM 6 is retasked to switch the
timer between slave and local
modes when using associated dis-
play as a remote timer. See page 7.