Rainforest EMU User Manual - Emu
www.rainforestautomation.com
EMU
™
User Manual
17
EMU
™ Configuration Screens
Restart
The Restart screen allows you to perform a
device restart by pressing the Top Button.
This will reboot your EMU
™ without losing
the connection to the smart meter. To
access this screen, press both buttons
simultaneously, then release.
Pressing the Bottom Button sends you to
the Select Language screen.
Select Language
The Select Language screen is used to
change the language displayed by your
EMU
™. This screen can only be
accessed in Configuration Mode, after
going through the Restart screen. To
enter Configuration Mode, press and
release
both
buttons
simultaneously.
Then press the Bottom Button to get to the
Select Language screen. The currently selected language will have an arrow beside it.
Press the Top Button to cycle between the different languages. Press the Bottom
Button to save the selected language. You will then be sent to the Set Rate screen.
Set Rate
The Set Rate screen allows you to
manually set the current price for electricity
or gas in cents per unit. This screen can
only be accessed in Configuration Mode,
after going through the Restart and Select
Language screens. The price shown will
zero, unless it has been previously set in
this screen. The rightmost digit of the price
will be flashing. To change this digit, press the Top Button and cycle through the
numbers 0-9 until the desired value is displayed. Then press the Bottom Button to save
Select Language
English
Select
Español
Français
Accept
Set Rate
000.00¢/kWh Change
Keep
Restart?
Restart
Skip