Rainforest EMU User Manual - Emu
www.rainforestautomation.com
EMU
™
User Manual
5
Quick Setup
Step 1: Check Contents of the box
The box should contain the following items:
a) 1 x EMU
™ Display unit
b) 4 x AA Batteries
Step 2: Register your EMU
™
In order for your EMU
™ to connect to the smart meter, you will need to register
your EMU
™ with your utility. Please follow the procedure provided by your utility.
You will need the following information, which is found on the Information Label
on the back of your EMU
™:
Note that it may take some time for your utility to enable the smart meter to
connect with your EMU
™. You should be advised by your utility how long this
will take. You must wait until this process is complete before proceeding; your
EMU
™ will not function correctly until the smart meter is enabled.
Step 3: Assemble your EMU
™
a. Open the battery cover on the back of your EMU
™
by pushing down on the catch at top of the door.
b. Insert 4 AA batteries exactly as shown on inside of
the battery compartment. Note that putting a battery
in backwards can be hazardous, and may cause
extensive damage to your EMU
™. Always use
alkaline batteries; never mix battery types. Replace
all batteries at the same time.
c. Replace the battery cover by inserting the bottom
tabs first, then snapping the catch closed.
2011 RAINFOREST AUTOMATION, INC.
©
MODEL: RFA – Z105
FCC ID: YCXRFA – Z105
IC: 8919A – RFAZ105
N27879
IN: 6E5D 0732 8E2A 6FB4
MAC: 0015 8d00 001a ab91
Install
Code
MAC
Address
This device complies with part 15 of the FCC Rules. Operation is
Subject to the following two conditions: (1) This device may not cause
Harmful interference, and (2) this device must accept any interference
Received, including interference that may cause undesired operation.