- DL manuals
- Ramblewood Green
- Cooktop
- GC1-28N
- User Manual
Ramblewood Green GC1-28N User Manual
Summary of GC1-28N
Page 1
User guide for gc2-43n gc2-43p gc2-48n gc2-48p gc1-28n gc1-28p ramblewood green www.Ramblewoodgreen.Com 1.
Page 2: General Information
General information these high efficiency cooktops are designed for domestic household use. The user manual contains important product safety & installation information. Your safety is of the utmost importance. Please ensure you read this booklet before attempting to install or use the appliance, an...
Page 3: Operation Guide
Operation guide operation any film or stickers on the cooktop surface should be removed before use. All operations are performed by means of the 2 control knobs. Knob controls electric ignition, safety device & flame level. To ignite, press, hold & turn the knob for 1~2 seconds to light up the gas, ...
Page 4: Installation
Installation installation and service must be conducted by qualified / licensed technician, in accordance with national & local regulation. Failure to comply will void the product warranty. always disconnect the appliance power before installation & maintenance. these cooktops are designed to be...
Page 5
Installation in kitchen cabinet with door (fig.13) it is recommended that a 30 mm clearance be left between the cooker top and the fixture surface (fig.13). Note: the adjacent furniture and all materials used in installation must be able to withstand a minimum of 85°c above the ambient temperature. ...
Page 6
Settling the hob for installation every cooktop is provided with a set of tabs for fitting to the unit with thickness from 3 to 4 cm, and a seal with adhesive on one side. • remove burners and grids. • turn the cooktop over and rest the top side on a cloth. • apply the self-adhesive seal “g” as illu...
Page 7
Built-in dimension model cut out dimension gc2-48n gc2-48p 268 x 480 mm (10.5 inch x 18.9 inch) gc1-28n gc1-28p gc2-43n gc2-43p a cardboard with cut out hole size is packed in each box. Please use it to outline & cut hole in the counter top. Do not attempt to cut the hole before you received the uni...
Page 8
Gas supply line connection you should find a l/elbow shape connector sealed in a small bag inside the box. This is a north america standard three quarter inches (3/4”) thread size connector for gas supply hose connection. If you can not locate this connector inside the box please contact ramblewood ...
Page 9
Gas type conversion (from ng to lpg or from lpg to ng) gas section types of gases gc2-48n, the hob comes with nozzles for natural gas(ng), gc2-48p, the hob comes with nozzles for lpg gc1-28n, the hob comes with nozzles for natural gas, gc1-28p, the hob comes with nozzles for lpg gc2-43n, the hob com...
Page 10
Regulation of the burner flame level; when switching from one type of gas to another, the minimum flow rate must be adjusted so the flame should not go out. To regulate the flame follow; • light up the burner • turn the knob to minimum level • the adjustment screw is located in the center of the sha...
Page 11: Cleaning and Maintenance
Cleaning and maintenance cleaning glass surface should be cleaned regularly. avoid using acid or chlorine-based cleaning products. burner & grids can be removed and cleaned with appropriate detergent. After cleaning it is very important to check that the burner flame distributor f and the cap ...
Page 12
Be able to rotate (fig.8). Then position the cap a and the ring b (fig.8). cleaning the trlple ring burner four holes( “h”) outside the crown can be cleaned by removing the flame divider (fig.9) and use a cotton bud to brush out any dirt trapped inside,. This procedure is necessary to ensure the...