User guide for gc2-43n gc2-43p gc2-48n gc2-48p gc1-28n gc1-28p ramblewood green www.Ramblewoodgreen.Com 1.
General information these high efficiency cooktops are designed for domestic household use. The user manual contains important product safety & installation information. Your safety is of the utmost importance. Please ensure you read this booklet before attempting to install or use the appliance, an...
Operation guide operation any film or stickers on the cooktop surface should be removed before use. All operations are performed by means of the 2 control knobs. Knob controls electric ignition, safety device & flame level. To ignite, press, hold & turn the knob for 1~2 seconds to light up the gas, ...
Installation installation and service must be conducted by qualified / licensed technician, in accordance with national & local regulation. Failure to comply will void the product warranty. always disconnect the appliance power before installation & maintenance. these cooktops are designed to be...
Installation in kitchen cabinet with door (fig.13) it is recommended that a 30 mm clearance be left between the cooker top and the fixture surface (fig.13). Note: the adjacent furniture and all materials used in installation must be able to withstand a minimum of 85°c above the ambient temperature. ...
Settling the hob for installation every cooktop is provided with a set of tabs for fitting to the unit with thickness from 3 to 4 cm, and a seal with adhesive on one side. • remove burners and grids. • turn the cooktop over and rest the top side on a cloth. • apply the self-adhesive seal “g” as illu...
Built-in dimension model cut out dimension gc2-48n gc2-48p 268 x 480 mm (10.5 inch x 18.9 inch) gc1-28n gc1-28p gc2-43n gc2-43p a cardboard with cut out hole size is packed in each box. Please use it to outline & cut hole in the counter top. Do not attempt to cut the hole before you received the uni...
Gas supply line connection you should find a l/elbow shape connector sealed in a small bag inside the box. This is a north america standard three quarter inches (3/4”) thread size connector for gas supply hose connection. If you can not locate this connector inside the box please contact ramblewood ...
Gas type conversion (from ng to lpg or from lpg to ng) gas section types of gases gc2-48n, the hob comes with nozzles for natural gas(ng), gc2-48p, the hob comes with nozzles for lpg gc1-28n, the hob comes with nozzles for natural gas, gc1-28p, the hob comes with nozzles for lpg gc2-43n, the hob com...
Regulation of the burner flame level; when switching from one type of gas to another, the minimum flow rate must be adjusted so the flame should not go out. To regulate the flame follow; • light up the burner • turn the knob to minimum level • the adjustment screw is located in the center of the sha...
Cleaning and maintenance cleaning glass surface should be cleaned regularly. avoid using acid or chlorine-based cleaning products. burner & grids can be removed and cleaned with appropriate detergent. After cleaning it is very important to check that the burner flame distributor f and the cap ...
Be able to rotate (fig.8). Then position the cap a and the ring b (fig.8). cleaning the trlple ring burner four holes( “h”) outside the crown can be cleaned by removing the flame divider (fig.9) and use a cotton bud to brush out any dirt trapped inside,. This procedure is necessary to ensure the...