RAMSET GYPFAST Instruction Manual - page 10
FUEL CELL AND METERING VALVE
FUEL CELL AND METERING VALVE
10
INSERTING FUEL CELL
With the Metering Valve Stem pointed toward the
front of the tool, insert the Metering Valve/Fuel
Cell Assembly .
As you slide the Metering Valve/Fuel Cell Assembly
into the GypFast tool, you will notice that there is a
Red Adaptor at the top of the Cylinder Pocket . As
is shown in the illustration, this Adaptor is designed
to ensure that the Metering Valve Stem is properly
aligned with the small hole, or orifice that leads to the
Combustion Chamber . Insert the Metering Valve
Stem into the orifice of the red colored Adaptor .
You complete the loading of Fuel Cell in the
GypFast tool by closing the Actuator Cover . You
do this by swinging it up and over the Fuel Valve/
Cylinder Assembly and pushing down until the
Actuator Cover snaps into position .
OUTDOOR WEATHER AND THE
GYPFAST TOOL
Use the GypFast tool outdoors, in clear weather,
when the Tool, Fuel Cell, and Battery are between
20°F (-7°C) and 120°F (49°C) . Colder temperatures
may damage the GypFast Tool and Battery . Hotter
temperatures may damage the Tool and Fuel Cell .
Fuel should be stored out of direct sunlight in
surroundings less than 120°F (49°C) . After extended
periods of continuous use, cool the Tool by running
the Fan Motor .
Operation when the Tool is less than 20°F (-7°C)
may damage the tool . Fuel Cells at cold tempera-
tures lose the required propellant force . Bring
the Tool, Battery, and Fuel Cell above minimum
operating temperature without direct exposure to
flame, and check the Battery .
CAUTION
The GypFast tool should not be used in the
rain or where excessive moisture is present .
These conditions may result in damage to tool
components and cause tool to malfunction .