RAMSET RL2+ Owner's Manual - page 4
Locked line angle
In the locked line angle position, the pendulum is in the locked position and will not automatically
level or plumb the lines. Use this mode to match an angle between any two points.
When in the locked line angle position, both the horizontal and
vertical beams will be on. The green LED will blink to indicate
you are in this manual mode.
Note: the unit cannot be changed between the level line
mode and vertical plumb line mode while in the locked angle
position.
Automatic leveling
When the pendulum is unlocked, it is free to automatically level or plumb.
In order for the RL2+ to automatically level, it must be within 5 degrees of level. When it’s within
this self-leveling range, the green LED will go on.
If the unit is 5 degree or more out of level, the laser beams
and the red LED will blink. If it’s out of level over 3 minutes,
the beams will shut off automatically.
To restart the unit, the pendulum lock should be pushed to
the Off position, and then pushed On again (far right position)
to start.
LINE button: Choose level, plumb, or cross lines
Press the LINE button on the top of the laser for 3 line choices. In addition, the unit has a plumb
up and down beam which is always on when the unit is on.
Use the line options button to cycle through the level (horizontal), plumb (vertical fan), or cross
line modes, as shown in the illustration.
4
Botón “MODE” (Modo) para usar el detector
Para trabajar al aire libre, utilice el detector láser opcional. Coloque el láser en el modo pulso
(necesario para que el receptor detecte el rayo) presionando el botón “MODE” (Modo). La luz LED
se encenderá. Presione nuevamente para salir de este modo.
Apagado automático
Para ahorrar batería, el láser tiene una función de apagado automático, y se apaga
automáticamente después de 1 hora, salvo que se desactive esta función. Para cancelar el
apagado automático, presione y mantenga presionado el botón “LINE” (Línea) al encender la
unidad. La luz LED verde parpadeará rápidamente para indicar que se desactivó la función de
apagado automático.
Indicador de pilas bajas
Cuando las pilas estén bajas, la luz LED roja, que está en la parte superior del láser, parpadeará
rápidamente. Cuando aparece la indicación de que las pilas están bajas, el láser se puede usar
durante una hora antes de que se apague completamente.
FIJACIÓN
Soporte para láser
1 1/4” x 5 1/4” x 2 3/8” (3.2 x 13.4 x 6 cm) de altura
Asegure el láser al soporte universal y colóquelo en el suelo para los
rayos de plomada vertical. El soporte está diseñado para colocarlo sobre
carriles de patas profundas.
Fijación del montante de metal
El soporte se fija magnéticamente a un montante de metal para las
aplicaciones de distribución.
Trípode
Utilice el orificio roscado de 1/4” x 20 que se encuentra en la parte
inferior de láser o en la parte inferior del soporte universal para fijarlo
al trípode de una cámara
Modo horizontal (auto nivelación)
presione 2 veces
línea predeterminada
presione 1 vez
Modo cruz (auto nivelación)
Modo vertical (auto nivelación)
Modo cruz (línea bloqueada)
21