RAMSET RL2+ Owner's Manual - page 6
CALIBRATION CHECK
We recommend that you check the instrument’s accuracy before initial use; then periodically to
ensure proper reference.
1. Set up the RL2+ about 6” (15 cm) away from a wall (a) and 12-15 ft. (4-5 m) from
another wall (b).
2. Turn on the unit to the automatic level setting (far right/unlocked position).
3. Carefully mark the center where the lines cross on Surface 1. This is A1.
4. Rotate the laser 180 degrees and mark where the lines cross on Surface 2 (this is B1).
5. Move the laser 6” away from Surface 2 and mark where the lines cross on Surface 2
(this is B2). (See right illustration)
6. Rotate the laser 180 degrees and mark where the lines cross on Surface 1 (this is A2).
7. Measure the distance between A1 and A2, and also between B1 and B2. If the
distances are the same, the laser is in calibration. If the difference between the two
sets of marks is greater than 1/8” (3 mm), the laser is out of calibration.
For more information on calibration, contact the distributor or local service center.
6
CARACTERÍSTICAS
Botón “Pulse Mode”
(Modo pulso)
Abertura del rayo horizontal
Abertura del rayo vertical
CÓMO USAR EL RL2+
Bloqueo del péndulo (posición Off)
El RL2+ es un instrumento de precisión y debe tratarse con
cuidado; tiene un mecanismo de péndulo para autonivelarse.
Cuando no se utiliza, el péndulo debe estar siempre en la
posición Off (apagado). El bloqueo del péndulo permite que el
instrumento soporte mejor las vibraciones presentes durante
el transporte o si se cae la unidad.
Al utilizar el láser, colóquelo en la posición de bloqueo
(posición media) o en la posición de autonivelación (no bloqueada/completamente a la derecha).
Consulte la siguiente página en la que se describen estos modos de operación.
Posición Off
(apagado)
Posición de bloqueo
Posición ON (encendido)
Compartimiento
para pilas: 3 pilas AA
LED de pulso
LED verde
de Modo
de trabajo
Pilas bajas/nivel no recomendable
LED rojo de rango
Botón de línea horizontal/
línea vertical/línea en cruz
Ventana del rayo
de plomada hacia arriba
Imanes
Ventana del rayo de
plomada hacia abajo
Tornillo de 1/4” de giro para
el montaje del soporte
Soporte del láser
Etiqueta de seguridad de la abertura
Etiqueta de peligro
(botón del alojamiento
del láser)
19