RAMSET T2 Instruction Manual - Installing The Battery
Installing the battery
• Insertthebatteryintothetool
as shown on the right with the
clip toward the rear.
• NotetheLEDlightontheright
side of the handle. After installing
the battery:
- If the light flashes green the
tool is powered.
- If the light flashes red the battery
requires charging.
- If the light is solid green and
the fan is running, the tool is
ready to use.
- If the light is solid red and the
fan is not on the battery needs
recharged.
Installing the fuel cell
• Thereisacaplocatedontherearof
the tool handle that covers the fuel
cell. Twist the cap 1/8 turn clockwise
and remove it.
• Insertthefuelcell,nosefirst,allthe
way into the recess.
• Replacethecapbyliningupthe
lugs on the cap with the notches in
the tool handle, push the cap in and
twist it 1/8 turn counterclockwise
to the locked position.
SAFETY INSTRUCTIONS
DANGER
SAFETY INSTRUCTIONS
DANGER
6
Battery is shown in the no contact
position. Push it fully down to lock it
in place.
Turn and remove cap
Insert fuel cell into recess