RAMSET XT540 Operator's Safety & Operating Instruction Manual - page 15
Manual is about: SEMI-AUTOMATIC, LOW VELOCITY PISTON TYPE FASTENING TOOL
of
16
INSPECTION / TOOL MAINTENANCE
15
INSPECTION / TOOL MAINTENANCE
Re-assembly is the reverse of
disasssembly
1. Position the barrel’s groove at the top.
2. Insert the barrel’s assembly into the
main housing and screw the knurled
collar by hand. (Do not over tighten).
3. After re-assembly check that the barrel
slides properly in the handle.
4. Slide the buffer onto the piston.
5. Slide the piston return spring onto the
piston.
6. Insert the piston assembly into the barrel.
7. Screw the magazine or the fastener
guide onto the barrel.
8. Without any power loads or fasteners,
test the tool for correct function by
cocking the tool and depressing the
trigger. If this test does not work, do
no attempt to use the tool.