RAMSET XT540 Operator's Safety & Operating Instruction Manual - page 9
TOOL OPERATION
DAILY FUNCTION TEST
Always check the tool first to make sure
that it does not contain a strip load or
fastener. Test the tool several times by
depressing the muzzle bushing fully on a
hard surface and pulling the trigger. You
should hear an audible click as the firing
pin releases. Let up on the tool and check
to be sure that the barrel has opened to the
semi- open position.
OPERATING THE RAMSET XT540
TOOL
Note: Refer to safety precautions before
attempting to operate the tool.
1. Select and insert the fastener.
Select the correct fastener for the
application (see Fastener Selection,
page 7). Point the tool down and away
from yourself and any other person.
1a. Tool fitted with single shot fastener
guide. Insert a fastener, HEAD FIRST
into the fastener guide at the front end of
the tool, making sure the fastener guide
stays in the forward position.
1b. Tool fitted with fastener magazine.
1 - Press the magazine release button.
2 - Slide the magazine cover down.
3 - Insert Ramset collated drive pins.
4 - Push the magazine cover back into
the closed position.
TOOL OPERATING INSTRUCTIONS
TOOL OPERATING INSTRUCTIONS
9
1. SELECT AND INSERT THE FASTENER
1b. TOOL FITTED WITH FASTENER
MAGAZINE
PUSH
1
2
PERFORM THE FUNCTION TEST WITH
EMPTY, UNLOADED TOOL
Empty