Rand McNally tnd 760 Install Manual

Other manuals for tnd 760: User Manual, User Manual

Summary of tnd 760

  • Page 1

    Introduction this guide addresses the installation procedures for the rand mcnally tnd™ 760 in-cab mobile communication device. We recommend reviewing the entire guide before beginning installation. If you would like more information about installation, system registration or troubleshooting, please...

  • Page 2

    Installation instruction connector: visible option connector: concealed option locate the truck’s diagnostic port. Remove the plug on the diagnostic port, connect the cable, and lock the collar in place. Choose the best way to route your cable after you plug your cable into the diagnostic port. Remo...

  • Page 3

    Mount the device above-dash option: route the cable from the diagnostic port to the area where the tnd™ 760 will be mounted, tucking the cable in the space between the windshield and dash. Behind-dash option: remove the dash panel and route the cable from the diagnostic port to the area where the tn...

  • Page 4

    Device registration instructions adjust the angle of the mount using the thumbscrew. Pull the suction cup lever up to release suction. Place and hold the mount suction cup against the mounting surface, then press the suction cup lever down until it snaps into place. Note: follow all local regulation...

  • Page 5

    Troubleshooting no power or intermittent power loss: check power connection ensure that the cable is secured to the device. Reestablish the cable connections by unplugging them, then plugging them back in. Make sure locking collar is turned. Check communications look for any crossed-out icons on the...

  • Page 6

    Alternative installation options contact rand mcnally customer support at 1-800-641-rand (7263) or fleetsupport@randmcnally.Com for more information on alternative installation options. © 2013 rand mcnally. All rights reserved. Specifications are subject to change without notice. Rand mcnally endeav...