Rane SIXTY-TWO Operation Manual - page 11
VirtualDJ 8
– Rane Sixty-Two
11
F. Master & Booth
27. MAIN VOLUME. Use this knob to control the
Output level of the Master Outputs.
28. SESSION OUT. Use this knob to control the
Output level of the Session Output.
29. SESSION IN. Use this knob to control the
level of the Session Input.
SESSION IN and OUT are typically used to chain
mixers together, through any line-level device may be
connected to the Session Input and mixed here.
30. BOOTH VOLUME. Use this knob to control
the Output level of the Booth Output.
G. Loop, Browser & Other Controls
31. LOOP/SAVE/SLIP
In Auto Loop mode, use this button to save the last
triggered loop to the 1
st
slot. If a loop is already saved (led
will be bright orange), use the same button to enable the
saved loop.
Hold the same button down for more than 1sec to delete
the saved loop.
In Manual Loop mode, use this button to trigger a loop of a
pre-selected size in beats or exit a manual loop.
In All modes, hold SHIFT down and then use this button to
enable/disable Slip mode on the left or right deck.
When Slip mode is enabled, several functions such as
scratching, HotCues, loops etc. will act temporary and the
track will return to the position it would have been if the
action was never triggered.
32. OUT/ROLL./SYNC OFF
In Auto Loop mode, use this button to enable/disable the
Loop Roll mode. If enabled (led bright orange) the applied
loops will act temporary and the track will resume to the
position it would have been if the loop was never triggered.
In Manual Loop mode, use this button to set a Loop Exit point. If a loop is enabled, use
the same button to enable/disable the Loop Out Wheel mode and then use the
jogwheel on the VirtualDJ GUI or a MIDI controller to fine adjust the Loop Exit point (led
will flash green). Press again to turn off this mode or the Loop button to exit.