Rane SIXTY-TWO Operation Manual - page 12
VirtualDJ 8
– Rane Sixty-Two
12
In All modes, hold SHIFT down and then use this button to set the left or right deck as
Master Deck (all other decks will sync to the Master Deck). Hold SHIFT down and then
hold this button for more than 1 second to set the Master Deck selection back to the
auto mode.
33. IN/LOOP/SYNC
In Auto Loop mode, use this button to trigger a loop of a pre-selected size in beats (led
will flash orange when enabled).
In Manual Loop mode, use this button to set a Loop Entry (In) point. If a loop is
enabled, use the same button to enable/disable the Loop In Wheel mode and then use
the jogwheel on the VirtualDJ GUI or a MIDI controller to fine adjust the Loop Entry point
(led will flash green). Press again to turn off this mode or the Loop button to exit.
In All modes, hold SHIFT down and then use this button to synchronize the tempo and
phase of this deck with the opposite (or the Master Deck if more than 2)
34. SELECT/BEATS ENC. Use this encoder to select the length of the applied loop in
beats. Turn clockwise to double the size and anti-clockwise to half the size.
Push the encoderto trigger the selected loop.
When a Loop is triggered, hold SHIFT down and then use the encoder to move the loop
forward or backwards by half the size of the applied loop in beats.
35. MANUAL/AUTO. Use this button to toggle between the Manual and Auto Loop mode.
36. SCROLL. Use this encoder to scroll through files or folders in the selected Browser
Window.
Hold SHIFT down and then use the encoder to cycle through the available views of the
Sideview (Automix, Sidelist, Karaoke, Sampler and Shortcuts)
Push the encoder to enter the Songs list (if the focus is on the Folders list) or load the
selected track to the left or right deck (if focus is on any other Browser window)
Hold SHIFT down and then push the encoder to add the selected track to the Automix
list.
37. BACK. Use this encoder to scroll through files or folders in the selected Browser
Window.
38. SP-ASSIGN. When 2 computers are sharing the same mixer, define which of them will
control/use the Sampler buttons.
H. Auxiliary/Sampler
This section controls the Output Channels 5 and 6 of the USB audio interface of the Rane
Sixty-Two. By default VirtualDJ Sampler is routed to this Input