Rangemaster Toledo 110 Dual Fuel User's Manual & Installation Instructions - Injectors
WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
29
A
B
C
ArtNo.311-0010 Injectors
Fig.8-1
A – Jet, B – Internal injector, C – External injector
ArtNo.0102-0011 - Screwing
the control valve bypass screw
Fig.8-3
ArtNo.270-0019 - Proplus tags 1
Fig.8-2
Check the technical data section at the back of the book
that the hob is convertible to the gas you want to use.
A suitably competent person must perform the conversion.
After conversion the installation must comply with the
relevant regulations and also the local electricity supply
company requirements. Read the instructions before
converting this appliance.
nn
Failure to convert the appliance correctly could
invalidate any warranty or liability claims and lead to
prosecution.
When servicing or replacing gas-carrying components
disconnect from the gas supply before starting operation.
Check the appliance is gas sound after completion.
DO NOT use reconditioned or unauthorised gas controls.
Disconnect from the electricity supply before servicing. Before
electrical reconnection, check that the appliance is electrically
safe.
Injectors
Remove the burner caps and heads. Remove the old jets
(Fig.8-1)
. Fit the new jets
(see ‘Technical Data’ at the back of this
book for the correct jets).
Reassemble in the reverse order.
Tap Adjustment
Pull off all the control knobs. Remove the fixing screws
underneath the control panel
(Fig.8-2)
.
The control panel will drop down slightly. It is held at the top
by two holes in the top edge, one at each end, that locate on
the tags on the inner panel. Lift the control panel clear of the
tags and pull forwards, taking care not to damage or strain
the wiring.
Bypass Screw Adjustment
Turn the bypass screw on each control clockwise to the stop
(Fig.8-3)
.
Refit the control panel.
Stick on Label
Stick the LP gas label over the natural gas part of the
appliance data label.
Pressure Testing
Connect the appliance to the gas supply. Check the appliance
is gas sound.
The gas pressure can be measured at one of the left-hand
hotplate burner jets. Lift off a burner head and fit the pressure
gauge to the jet. Using a match, turn on and light one of the
other burners. Turn on and press in the control knob for the
burner with the pressure gauge fitted.
After checking the pressure, turn off the taps and replace the
burner head. Reassemble the burner top, making sure it is
reassembled in the correct way on the burner body.
Check the appliance is gas sound.
Check operation of all the burners.