Rangemaster Toledo 110 Dual Fuel Users Manual & Installation - page 26
26
Fit the Handles
Remove the 4mm Allen screws from the doors with the
hexagon key tool. Use the screws to fit the door
handles.
The handles should be above the fixings.
Remove the 4mm Allen screws from the top corners of
the fascia and fix the front handrail in position.
Fitting a stability bracket
A stability bracket or chain (not supplied by with the
cooker) should be fitted when the cooker is connected
to a flexible gas supply.
When fitting a stability bracket read these instructions
together with the leaflet supplied with the bracket.
1.
Place the cooker in its intended position and level
the cooker.
2.
Draw a pencil line 100mm from the front edge of
the levelling feet.
3.
Mark the centre line for the bracket by measuring
550mm from the left hand side of the cooker.
4.
Lower the front roller and move the cooker forward.
5.
Measure back from the pencil line 550mm to locate
the front edge of the bracket. Fix the bracket to the
floor.
6.
Measure the height from floor level to engagement
edge in back of cooker. Add 3mm to this dimension
and assemble the stability bracket to this height.
(i.e. from floor level to underside of the top
member) and ensure the bracket does not foul the
oven burner assembly.