Raritan PX3TS Quick Setup Manual

Manual is about: Transfer Switch, Xerus Firmware v3.4.0, PX3TS-200 R Series

Summary of PX3TS

  • Page 1

    Px3ts transfer switch quick setup guide 1 qsg-px3ts-0a-v2.6-e  255-80-0032-00 rohs raritan px3ts quick setup guide the px3ts transfer switch provides ac power to rack it equipment from one of two ac power sources, and automatically selects which source powers the load based on power availability an...

  • Page 2

    Px3ts transfer switch quick setup guide 2 qsg-px3ts-0a-v2.6-e  255-80-0032-00 rohs 2. Adjust slide-rail assemblies to match your rack posts and fasten them to the rack using your own fasteners. 3. Line up the mounting brackets with slide-rails and push this product into rails. 4. Fasten the front m...

  • Page 3

    Px3ts transfer switch quick setup guide 3 qsg-px3ts-0a-v2.6-e  255-80-0032-00 rohs rear view this is the rear view of px3ts-1876r. Your px3ts may look slightly different if it is a different model. 1. Inlets 2. Fuses - one per inlet 3. Outlets 4. Usb-a port 5. Console port qs rule testing indicator...

  • Page 4

    Px3ts transfer switch quick setup guide 4 qsg-px3ts-0a-v2.6-e  255-80-0032-00 rohs off: neither inlet is active because of an alarm or internal failure or because both inlets go critical. See manual transfers (on page 4) for restoring power. Qs rule automatic transfers an automatic transfer to the ...

  • Page 5

    Px3ts transfer switch quick setup guide 5 qsg-px3ts-0a-v2.6-e  255-80-0032-00 rohs for example, 192.168.84.4 cycles in this sequence: 192, 168, 84, 4 note: if your network only supports ipv6 or static ipv4 addresses, the ip address must be configured using a serial or usb port. See addendum (on pag...

  • Page 6

    Px3ts transfer switch quick setup guide 6 qsg-px3ts-0a-v2.6-e  255-80-0032-00 rohs 3. Enter deassertion hysteresis values. Qs rule addendum network configuration via an rs-232 or usb port step 1: connect the px3ts to a computer connect the px3ts to a computer via an rs-232 or usb cable. Rs-232 conn...

  • Page 7

    Px3ts transfer switch quick setup guide 7 qsg-px3ts-0a-v2.6-e  255-80-0032-00 rohs 4. The px3ts prompts you to log in. Both user name and password are case sensitive. A. At the username prompt, type admin and press enter. B. At the password prompt, type raritan and press enter. 5. If you are prompt...

  • Page 8

    Px3ts transfer switch quick setup guide 8 qsg-px3ts-0a-v2.6-e  255-80-0032-00 rohs e. After enabling the ipv4 or ipv6 protocol in the earlier step, configure the ipv4 or ipv6 network parameters. To set use this command ipv4 configuration method network ipv4 ipconfigurationmode = dhcp (default) or s...

  • Page 9

    Px3ts transfer switch quick setup guide 9 qsg-px3ts-0a-v2.6-e  255-80-0032-00 rohs note: to use the edimax ew-7722und or raritan usb wifi wireless lan adapter to connect to an 802.11n wireless network, the handshake timeout setting must be changed to 500 or greater, or the wireless connection will ...