Rasmussen Solaire Anywhere User Manual - page 13
Page 11
Care of Stainless Steel (cont’d)
RUST MARKS
When this type of staining occurs it is
unlikely that rusting of the stainless steel
itself causes the marks. Similar marks can
be found with both porcelain and plastic
sinks. The rust marks are more likely to
be the result of small particles of “ordi-
nary”steel which have become attached
to the surface; these have subsequently
rusted in the damp environment. The most
common source of such particles is from
"wire-wool" scouring pads, but contami-
nation may also occur from carbon steel
utensils and cast iron water supply pipes.
These brown marks are only superficial
stains, which will not harm the Grill; they
should be removable using a soft damp
cloth and a multi-purpose cream cleanser.
Occasionally, it may be necessary to
resort to a proprietary stainless steel
cleanser, to return the surface of the Grill
to its original condition. To avoid re-
occurrence of any "rust-staining" it is
essential that the source of the contam-
ination be eliminated.
PITTING
Another form of corrosion, which occa-
sionally occurs in stainless steel, is pitting
of the surface. The reason for this corro-
sive attack can usually be attributed to
certain household products, for example:
Bleaches
Most common domestic bleaches & steril-
izing solutions contain chlorine in the
form of sodium hypochlorite. If used in
concentrated form, bleaches can attack
the stainless steel, causing pitting of the
surface. They should always be used to
the strengths prescribed by the manufac-
turer and should be thoroughly rinsed off
with clean water immediately after use. All
cleaning agents containing hypochlorites
are unsuitable for long term contact with
stainless steel and, even when used in the
highly diluted form, they can give pitting
under certain conditions.
Foodstuffs
In general stainless steel is fully resistant
to all foodstuffs in common use. Only in
isolated cases, such as when concentrated
salt and vinegar mixtures are allowed to
remain in contact with the steel for a long
period, can any surface marking result.
GRILLING GRIDS
Routine cleaning of the grill grids is best
accomplished by scrubbing the grids with
a brass or stainless steel brush immediately
before and after cooking, while the grill
is hot. Wear a barbeque mitt to protect
your hand from the heat while cleaning.
When needed, remove the grids from the
grill and scrub with a soap solution or
oven cleaner. Rinse thoroughly, and
allow the grids to dry completely before
reinstalling onto grill.