Ratoc Systems CBU2 User Manual - page 14
13
3-4. Installing the driver(Windows XP)
Before you install the driver, check to see if Windows XP Service Pack 1 is already installed or not.
To verify Service Pack 1 is installed, right-click on [My Computer],and then select
[Properties]. If you can find a “Service Pack 1” string as shown below, Service Pack 1 is already
installed in your system.
If the Service Pack 1 is already installed in your system, proceed to Section A.
If the Service Pack isn’t installed in your system, proceed to Section B.
A. Installing the driver in Windows XP with Service Pack 1
1.
If the Service Pack 1 is already installed in your system, insert the CBU2 CD-ROM into the
CD-ROM drive. The installer will start up automatically. If the installer won’t start up auto-
matically, run [Setup.exe] at the CD-ROM. The following wizard will open. You are
prompted to insert the CBU2.