Raven AccuBoom Installation Manual - page 8
GVM Predator and Prowler ('08 & Older) CAN AccuBoom Installation Manual
6
5. Route the CAN and power cables form the AccuBoom node to the cab:
a. Locate the CAN terminator behind the right corner of the machine
cab.
b. Remove the CAN terminator (P/N 063-0172-369) from the CAN
cable.
c. Connect the 24 foot CAN tee cable (P/N 115-0171-363) in place of
the CAN terminator previously removed.
d. Route the CAN tee cable (P/N 115-0172-363) back to the previously
installed CAN AccuBoom cable (P/N 115-0171-591).
6. Connect the CAN cable to the product CANbus.
a. Connect the CAN tee cable (P/N 115-0172-363) to the CAN
AccuBoom cable (P/N 115-0172-591).
b. Install the previously removed CAN terminator (P/N 063-0172-369)
to the other connector of the CAN tee cable (P/N 115-0171-363).
7. Connect power and ground:
a. Route the red power and white ground wire to the control box located
behind the right corner of the machine cab.
b. Connect the red power wire to a source of clean, switched battery
power.
c. Connect the white ground wire directly to the battery ground.
8. The GVM Prowler/Predator CAN AccuBoom installation is now
complete. Install the AccuBoom Activation Key in Viper and the
AccuBoom system is ready for operation.