Rayburn Heatranger 440 User Instructions - page 12
Modifying the HEATING Programme
The heating programme has three pairs of
ON/OFF
switching times per day. Each time can be set between
3.00 am and 2.50 am (on the next day) to allow you to
programme the heating to stay on past midnight if
required.
a.
Move the slider switch to the
HEATING
position. ‘SET
HEATING’ will show briefly to verify this action.
b.
Now follow the same procedure to set the times as
described in ‘
Modifying the Cooker Programme
’
(Page 11), Steps
b.
to
i.
Exiting HEATING Programming Mode
To exit
HEATING
programming mode, move the slider to
the
RUN
position. This can be done at any time during the
programming process, and any changes made and
confirmed with the button will have been saved.
NOTE:
If the unit is left in
HEATING
Programming mode
for more than 10 minutes without the slide being moved or
any buttons pressed, the message ‘MOVE SLIDER’ will
be displayed. Press a button to finish programming, or
move the slider to the
RUN
position.
Disabling/Enabling Time Periods (for
Heating and/or Cooker)
To disable any of the time periods
ON 1
to
OFF 1
,
ON 2
to
OFF 2
, or
ON 3
to
OFF 3
, simply set the
ON
times and
its paired
OFF
time to the same time, and the programme
will just ignore them.
To re-enable the time period, simply set the two
ON
and
OFF
times to be different.
Choosing the Operating Mode (for Heating
and/or Cooker)
The operating mode may only be changed when the slider
is set to the
RUN
position.
A green
INDICATOR LAMP
shows when the heating or
or cooker is switched
ON
.
Two
MODE
buttons are provided to select the Operating
Mode and therefore how the heating and cooker are
controlled.
Heating has four possible
Operating Modes
; these are
OFF
,
AUTO
,
ONCE
,
CONT
. Pressing the heating
MODE
button scrolls round these modes in sequence, and the
display indicates which mode is currently active.
l
OFF Mode
The heating will remain
OFF
.
l
AUTO (Automatic) mode
The heating will be switched
ON
and
OFF
according to
the heating programme.
l
ONCE mode
The heating will come
ON
at the first programme
ON
time, and go
OFF
at the last programmed
OFF
time.
l
CONT (Continuous) mode
The heating will remain
ON
continuously.
The cooker
MODE
button operates in the same way as
described above for the heating
MODE
button.
Overriding the Operation Without Changing
the Programmes
In
AUTO
and
ONCE
operating modes, the
OVERRIDE
buttons switch the heating or cooker
ON
or
OFF
without
altering programme.
When the indicator lamp is
ON
, pressing the
OVERRIDE
button switches the heating or cooker
OFF
until the next
programmed
ON
time.
When the indicator lamp is
OFF
, pressing the
OVERRIDE
button switches the heating or cooker
ON
until the next
programmed
OFF
time.
The Electronic Display will provide you with information
about the override.
12
Fig. 5
DESN 516079
Fig. 6
DESN 516080
Fig. 7
DESN 516081
OPERATING YOUR PROGRAMMER