Raychem h910 Installation Instructions Manual - page 2
H910 Installation Instructions
12"
Bus wires
Core
Inner jacket
Braid
Outer jacket
(only on H612/H622)
2"
2"
1
The instructions are shown for a tee connection. Splice connections are done the same way, without the third heating cable section.
• Allow 12" of extra
heating cable as
shown. If necessary
trim cables evenly.
WinterGard Heating Cables
• H311, H611 and H621 do not have an
outer jacket. Proceed to Step #3.
• Lightly score completely around and
then down outer jacket.
• Bend heating cable to break jacket at
score then peel off outer jacket.
Do not cut braid
or inner jacket.
2
3
1"
• At the end of
each heating-
cable section
lightly score
completely
around and
down inner
jacket.
• Bend heating cable to
break jacket at score, then
peel off inner jacket.
Do not cut
bus wires.
4
1/4"
1/4"
• Notch core at the end.
• Twist back and
peel bus wires
from core.
5
• For H612 and H622, unravel the braid back to the outer jacket. For
H311, H611 and H621, unravel the braid back 2 inches .
• Position braid on same side of each heating cable section.
• Straighten the braid and twist into a “pigtail”.
Splice or Tee Connections