Raymar RT20 Series Quick Start Manual - 3 Getting Started
3: Getting started
Raymar RT20xx Series Quick Start Guide
Issue: 1.2
Page 7 of
15
3 Getting started
Note: images in this document show the RT2021 model. LEDS on other models may
vary.
3.1 Serial number
When you receive your RT20xx Series router package retain the outer packaging. The
label containing the model number, serial number (S/N) and part number (P/N) is located
on the side of the packaging box.
Each RT20xx Series router is assigned a unique serial number. Record your device serial
number on your warranty card or somewhere you can easily access it. You must
reference your unique serial number (S/N) when you contact Raymar support for
installation and configuration confirmation or should you request service on the device.
Unpack the contents. There is a matching label located on the bottom of the router.
3.2 Inserting the SIM card
1. Ensure the unit is powered off.
2. Hold the SIM card with the chip side facing down and the cut corner top left.
3. Gently push the SIM card into SIM slot 1 until it clicks in.
4. To remove the SIM card, gently push the SIM card. The card will click out.
WARNING
The SIM card MUST be inserted into the router before the unit is powered on.
Do not insert or remove the SIM card after the unit has been powered on.
3.3 Connecting the antenna
The RT20xx Series router is shipped with one antenna suitable for the model you
ordered. If you require antenna diversity, contact your reseller.
Screw the antenna into the back MAIN SMA connector.