Rip Curl ATS Oceansearch Instruction Manual - Tide Setting.

9

B

B

B

TIDE SETTING.

-Press MODE/SET to advance to TIDE SET MODE.

-After preset tide location name has finished scrolling, press and HOLD the LAP/RESET 

for 2 seconds to enter beach setting mode.

-To toggle between REGIONS use START/STOP & LAP/RESET.

When you find desired region press MODE/SET.

-Use START/STOP & LAP/RESET to toggle through to your desired COUNTRY.   Press 

MODE/SET to lock in your country.

-Use START/STOP & LAP/RESET to toggle to desired BEACH.

-Press and HOLD MODE/SET for 2 seconds to save selected beach.

-Once you set your beach you can use the START/STOP & LAP/RESET to toggle through 

all tide information for the day selected.

CUSTOMIZE A BEACH

In  the  case  where  one  of  the  200  preset  beaches  isn’t  your  local  beach  you  can 

CUSTOMIZE  the  tide  data  for  any  of  the  200  preset  beaches  to  match  your  local 

beaches’ tide.

-Firstly,  use  the  tide  set  procedure  above  to  find  the  preset  beach  closest  to  your 

target location.

-Then find the time offset between the selected preset beach and your target beach. ie 

Torquay plus 45 minutes equals my local beach.

-To activate CUSTOM setting, in TIDE SET mode press and HOLD MODE/SET for 2 

seconds, OFFSET appears and a ZERO digit will flash. 

-Use START/STOP & LAP/RESET to increase or decrease the time offset you would 

like to make.

-Press MODE/SET to lock in your offset. The watch will then ask you to rename the beach 

you have customized the preset tide data to.

-Use  START/STOP  &  LAP/RESET  to  scroll  through  the  alphabet  and  change  the 

selected letter.

-Press MODE/SET to move to the next letter.

-Once complete, HOLD MODE/SET for 2 seconds to save all information

NOTE: To leave the customized beach named as CUSTOM just put in the time offset 

then press and HOLD MODE/SET for 2 seconds to save.