Riva RC4602SV01-2017-A Quick Installation Manual - page 2
RC4602SV01-2017-A
2
2. Install IP device
1) Loosen the three screws on the
top of the camera, and detach the
safety ring from the top.
2) Twist the top of the camera
counter-clockwise to separate it from
the main body, and push the lever of
the plastic cover at the bottom of the
top outward to open it. Then, insert
the provided terminal block to the
corresponding places on the PCB.
3) Drop all the necessary cables
through the neck of the camera’s top,
and fix the top to your installed
bracket or on the designated spot.
4) Install the provided ferrite cores on
the cables by winding cables around
the ferrite cores once. Refer to the
image on the left.
5) Connect all the cables to the
corresponding connectors by referring to
the image on the previous page. Then,
close the PCB on the top of the camera.
6) Hook the safety ring to the top of
the camera while carefully holding the
camera's main body, and align the
triangle marks on the top with the
main body.
7) Twist the main body counter-
clockwise once the camera’s top and
the main body are properly aligned,
and tighten the three screws on the
top.
Note
i
The internal heater does not work when the device is powered via PoE.
Caution
!
To prevent products from damage, place the camera on stable and non-vibrating
surfaces. If the stability is in doubt, consult safety personnel for reinforcements, and then
proceed with the installation.
DI/DO cable
LAN cable
power cable
Audio cable