Riva RC4602SV01-2017-A Quick Installation Manual - page 6
RC4602SV01-2017-A
6
6. Reboot
Perform the following procedures to reset your device:
On the Device
1. Press the reset button for 2 seconds while the device is powered on.
2. Wait for the system to reboot.
Caution
!
Please do not hold the reset button for more than 2 seconds. Otherwise, the camera
may be switched to its factory default settings.
On the Camera’s Webpage
1. Go to Setup > Maintenance > Reboot.
2. Click Reboot to reboot the device.
7. Factory Default
Resetting the device back to the factory default will initialize all parameters including the IP address back to
the factory defaults. To reset back to the factory default:
On the Device
1. Press the reset button and hold it while the device is powered on.
2. Release the button after 10 seconds.
3. Wait for the system to reboot.
On the Camera’s Webpage
1. Go to Setup > Maintenance > Reset All Settings.
2. Select the items that you want to keep from the initialization among network settings, user account
information, and time zone setting.
3. Click Reset All Settings.
Note
i
The factory default settings can be inferred as follows:
IP address: 192.168.xx.yy
Network mask: 255.255.0.0
Gateway: 192.168.0.1
User ID: root
Password: pass
Reset Button