Riva RC6702HD-6311 Quick Installation Manual - page 2
RC6702(63)03-2014-B
2
2. Installation
There is only one type of mounting the device explained in this manual. Refer to the device’s installation guide
for more various mounting types.
Sealing gaps is recommended as gaps may appear after the camera installation.
Gaps may cause problems such as moisture, water leakage and etc., which negatively
affects the operation of the camera if gaps remain unsealed.
To prevent products from damage, place the camera on stable and non-vibrating
surfaces If the stability is in doubt, consult safety personnel for reinforcements, and
then proceed with the installation.
Caution
!
Caution
!
1) Place the installation template (paper)
included in the package on the desired
installation surface.
2) Drill three holes in correct positions based
on the template paper, and insert the anchor
blocks into the holes.
3) Attach the silicon waterproof band included
in the package to the camera’s mounting
surface by aligning it with the three alignment
holes.
4) Connect the required cables including a
power cable and a LAN cable to the device.
Refer to 1. Part names and positions for more
details.
5) Place the camera body to match the three
alignment holes with the three anchor blocks,
and hold the camera against the surface
where the camera will be mounted.
6) Tighten the anchor blocks with the screws.
7) Adjust the heading direction of the camera.
Please refer to 3. Adjust angle of the camera
for more details.
8) Attach the lens cover on the main body by
rotating it clockwise.
9) To adjust zoom and focus, refer to
4. Adjust Zoom and Focus.