S.R.Smith SWIM-N-DUNK & COMMERCIAL BASKETBALL GAMES Assembly And Installation Instructions - page 3
3
COMMERCIAL AND SWIM-N-DUNK PARTS LIST
NOTE: Two in-deck plastic anchors (AS-100P) for concrete decks are required to install the game.
ASSEMBLY INSTRUCTIONS
1. Begin by locating the basketball posts and the
cross brace as shown in FIGURE 1. Attach the
cross brace to the posts with the stainless steel
split tees and hardware as shown in FIGURE 2.
2. Insert a 3/8” L bolt w/pushnut into each hole
drilled in the top of the backboard frame. With the
L bolts inserted in each hole, press the pushnut up
against the backboard frame to hold the L bolt in
place.
3. Attach the backboard to the posts by
placing the L bolts through the top holes
of the posts as shown in FIGURE 3 and
fastening with the 3/8” lock nuts. Do not
completely tighten at this time. Do not
place the black nut caps over the lock
nuts until later in the assembly process.
ITEM #
PART #
DESCRIPTION
QTY.
1
SPG-101
Basketball Rim & Net
1 ea.
2
SPG-100
Basketball Backboard
1 ea.
3
20-110/20-132*
Basketball Post Assembly (*Commercial Post Assembly)
2 ea.
4
20-104
Basketball Post Cross Brace
1 ea.
5
2019061
Split Tee Half
4 ea.
6
2020049
3/8” x 2-1/2” Carriage Bolt
4 ea.
7
5-139
3/8” Hex Nut S/S
4 ea.
8
05-33-114
7/16” x 1” Flat Washer
8 ea.
9
05-33-115
5/16” Hex Flange Nut
4 ea.
10
5-302
5/16”-18 x 2” Hex Flange Bolt
4 ea.
11
5-105
3/8” x 2-1/2” S/S L Bolt w/Pushnut Bolt Retainer
2 ea.
12
5-141
3/8” Lock Nut S/S
2 ea.
13
05-608
3/8” x 1” Nut Cap, Black
2 ea.
14
6-630
5/16” Dual Plastic Spacer
2 ea.
15
SPG-102
Basketball (not pictured)
1 ea.
16 SPG-103
Basketball
Needle
(not pictured)
1 ea.
FIGURE 2
FIGURE 3