1. DL manuals
  2. SA Sport
  3. Fitness Equipment
  4. 228
  5. Assembly, And Care Manual

SA Sport 228 Assembly, And Care Manual

Summary of 228

  • Page 1

    Assembly and care instructions performance series single bar trainer 228 version: 8920019 (revised 06/15) sales and service sasportonline.Com sa sport – canada and international 135 forestview road, po box 40 orillia, ontario, canada l3v 6h9 toll-free: (800) 563-6479 telephone: (705) 325-2274 fax: (...

  • Page 2

    228 performance series single bar trainer assembly instructions page 2 of 9 the performance series single bar trainer requires 70% less anchor space than a conventional single bar and has platforms on the inside and outside of the uprights. The inside platform can be removed quickly and easily when ...

  • Page 3: 1. Assembly Instructions

    228 performance series single bar trainer assembly instructions page 3 of 9 1. Assembly instructions 1.1. Single bar trainer pre-assembly do not climb or stand on the bases until they are anchored to the floor. 1. Place the upright bases in the approximate location where they will be used. 2. Pre-as...

  • Page 4

    228 performance series single bar trainer assembly instructions page 4 of 9 3. Slide the pre-assembled upright tubes into the base tubes. 4. Place bases where they will be permanently located. 5. Remove the lock pin on the carrier and lift off hold down bracket (see photos below). 6. Attach the rail...

  • Page 5

    228 performance series single bar trainer assembly instructions page 5 of 9 1.2. Installing concrete anchors to determine anchor locations, please refer to the following section for your specific equipment to be anchored. Tools required (customer supplied): • tape measure • anchor setting tool or pu...

  • Page 6

    228 performance series single bar trainer assembly instructions page 6 of 9 1.3. Anchoring bases 1. For one base only: a. Mark the center hole and the two corner holes (use a marker, a pencil or chalk). B. See floor anchor installation instructions on previous page. C. Drill and install only the cen...

  • Page 7

    228 performance series single bar trainer assembly instructions page 7 of 9 1.4. Installing cable floor anchors 1. Begin by marking out the locations for the cables anchors as shown in the diagram below. 2. Drill and install anchors as explained in the anchor instructions on page 5. Read & follow an...

  • Page 8

    228 performance series single bar trainer assembly instructions page 8 of 9 1.5. Changing rails install the rail into the carriers as shown in the following photos. Ensure hold down bracket and locking pin are installed correctly. 1.6. Height adjustment 1. Loosen the t-handle spinlock on the rail ca...

  • Page 9: 2. Safety

    228 performance series single bar trainer assembly instructions page 9 of 9 2. Safety warning any activity involving motion or height creates the possibility of serious injury including permanent paralysis and even death, from landing or falling on the neck, head, or other parts of the body. You ass...