SA Sport 228 Assembly, And Care Manual - page 8
228 PERFORMANCE SERIES SINGLE BAR TRAINER
Assembly Instructions
Page 8 of 9
1.5. Changing Rails
Install the rail into the carriers as shown in the following photos.
Ensure hold down bracket and locking pin are installed correctly.
1.6. Height Adjustment
1. Loosen the T-Handle Spinlock on the rail carrier
2. Pull the Gravity Snaplock out of hole in adjusting tube
3. Move the rail up or down to the desired position
4. Make sure the Gravity Snaplock fully engage in a hole at the same height on both adjusting tubes
5. Tighten the T-Handle Spinlock on the rail carrier
7
The Rail Carrier T-Handle Spinlock must be screwed down tight in a clockwise direction
after adjustment is completed and before using the Apparatus.
Ensure the Upright Base T-Handle Spinlock is tightened on the Upright Tube fully after
adjusting the height of the Bar.
Step 1: Remove the locking
pin and hold down bracket.
Step 2: Place rail into
carrier.
Step 3: Replace hold down bracket
and locking pin
Gravity Snaplock (pin)
T-Handle Spinlock (clamp)