SAB Heli Division Goblin 570 User Manual - page 26
HA027-S
2 x HA023-S
Batteries
* Follow the figure for assembly the battery. You can see 6S solution (fig 1,2,3,4 ) and 12 S solution ( fig 5,6,7,8 ).
* With 12S configuration, it is recommended to orient down the wires in the front battery (Fig 7).
* Before permanently mounting the batteries onto the battery tray, check the ideal position for the best center of gravity.
* Before flight, make sure the battery is locked in place; the battery tray must be inside the slots on both sides!
* Battery 6S 5000/5500 mAh. Max dimension 50x60x200mm
* Battery 12S 2600/3300 mAh. Max dimension 50x45x280mm
Battery Tray
(H0311-S)
Double - Sided
Adhesive Tape
Battery
CANOPY
The canopy touches the frames on the Goblin, this is normal and expected as it is part of the
design. To avoid canopy damage due to high frequency vibration, it is necessary to attach the
adhesive foam tape HA006 to the canopy. [Bag 8] (Fig 5).
Install the canopy grommets [Bag 8] as shown in Figure 5.
The canopy locks in the front as shown by the arrow in Figure 6 and in the rear by the canopy
screws H0810-S [Tray 2] (Fig 7).
BATTERY 6S
BATTERY 12S
Battery
Double - Sided
Adhesive Tape
Battery Tray
(H0311-S)
Front
Front
Copyright @ 2014 - SAB Heli Division - All rights reserved
Page 24
Chapter 14, Battery