Saeco PHEDRA Manual - page 44
English
44
9 - OPERATION AND USE
Important
This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have
been given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
9.1 Beverage
selection
This vending machine is able to dispense 15 beverages.
The following are the conditions necessary to select a
beverage:
- the vending machine has reached the set temperature after
the start-up. Otherwise, once a beverage key is pressed,
the display shows the message “HEATING”;
- the credit available is sufficient or the vending machine has
been set in free mode. If this is not the case, the display
shows the message “INSERT XXX”;
- there is no error condition that prevents the dispensing of
beverages.
- the beverage selected is enabled. If this is not the case,
the message “NOT AVAILABLE” will be displayed;
- there is no block condition for the beverage selected. If this
is not the case, the message “BEVERAGE XXX” alternated
with “NOT AVAILABLE” is displayed before the key is
pressed. After the key is pressed, the display shows the
message “NOT AVAILABLE”;
Important
During the brewing of a beverage:
- payment systems are disabled;
- the first line on the display shows the programmable
dispensing message (default message is: “WAIT FOR
PRODUCT”).
Beverage selection
If the vending machine is not set to dispense free beverages,
insert the credit required.
Press the key corresponding to the beverage required.
When the beverage is dispensed, the message “REMOVE
CUP” is displayed. Take the beverage out of the dispensing
outlet.
Warning
To avoid scalding, wait for the end of brewing signal (the
message “REMOVE CUP” will appear on the display) before
placing your hand in the dispensing outlet.
Do not open the dispensing outlet door while the vending
machine is brewing.
In case of failures or product missing during the brewing
10 - CLEANING AND
MAINTENANCE
Warning
Unplug the power cord before performing any cleaning and/
or maintenance operation.
It is prohibited to perform cleaning or maintenance operations
on the internal components of the vending machine with the
safety microswitch disabling key inserted.
The Manufacturer declines any liability for any damage or
malfunctioning caused by incorrect or poor maintenance.
Important
During the loading operations do not stress any of the live
electrical parts and do not clean them with damp cloths.
Warning
Avoid using chlorine-based tablets so as to prevent oxidation
phenomena inside the vending machine.
phase, a message indicating the cause of this stop will
appear on the display.
Messages and special warnings are listed in section 11.
9.2 Cappuccino with cold
milk function (only for
Cappuccino version)
This model is equipped with a special frothing system, which
automatically draws milk from an external container (not
supplied), like: bottle or Tetra Pak.
To ensure correct operation, make sure that:
a. The Cappuccinatore is fully inserted on its support hose
b. The Cappuccinatore is clean, correctly closed, and that the
steel needle is also clean and fully inserted in its seat.
c. The suction hose has no constrictions or bends that might
hinder correct milk suction and flow (see Fig. 69).
The machine has been tested for correct operation with milk
temperatures between 4 °C and 15 °C.
Important!
It is recommended to always use cold milk and to comply
with the health and fresh food storage regulations in force in
the country of use of the machine.
For more information visit www.Gumball.com | 800-260-0010 | +1-214-550-5079