Safescan 2985-SX User Manual - 1. Batch Counting
www.safescan.com
ENGLISH
Batch counting enables you to create equal stacks of a pre-defined number of banknotes.
•
Press [BATCH] to enter batch number selection mode. The pre-set batch number will start with 100, this number is shown
on the top right of the screen.
•
Pressing again will toggle between the pre-set batch numbers: 100 50 20 10 0. When the batch setting is
off, the display shows ‘---’.
•
To set any other batch number, press to increase the batch number by 1 (short press) or 10 (long press). Continue
until you have reached your desired batch number.
When a batch number has been set, the banknote counter will stop counting when the pre-set number of banknotes has been
reached. Remove the banknotes from the stacker, the banknote counter will automatically continue counting until again the
pre-set batch number has been reached.
CLR
+1/+10
CUR
MIX
R:
S:M
15-12-2015
12:05
PCS
0
VAL
0
****
BATCH
B:100
CLR
ADD
REP
MENU
MODE
CLR
CLR
+1/+10
CUR
ADD
REP
MIX
R:
S:M
15-12-2015
12:05
PCS
0
VAL
0
****
MENU
MODE
BATCH
B:---
ADD
When the ADD function is switched ON, the banknote counter will add the current count result to the previous count result.
Press to switch the Add function on. ‘ADD’ will be shown on the top middle on the screen. The banknote counter will
now add each count result to the previous count result.
Press the button to set the count to 0. Press again to switch the ADD function off.
6. ADDITIONAL COUNTING FUNCTIONS
1. BATCH COUNTING
BATCH
+1/+10
2. ADD FUNCTION
ADD
CLR
ADD