Safety Vision 7000-NVR User Manual - page 30
Device Name:
Enter a unique name. A device can be
uniquely identified by this name.
Restriction:
Maximum allowed length for device name is 15
characters.
Type:
Camera model of selected device.
Recording Type:
If “Combine Event & Continuous”
checkbox is checked, user will get two options for stream
selection:
•
Continuous & Event:
Enable Continuous and Event
stream. Even files can be generated from continuous
data.
•
Live:
Enable Live video stream to view video on web
interface. Select Low resolution stream (
bitrate below 2Mbps for live looking.
If “Combine Event & Continuous” checkbox is not checked,
user will get two options for stream selection:
•
Continuous:
Enable Continuous stream.
•
Event:
Enable Event Stream
Stream Type:
•
Main:
Main stream is a high resolution stream.
•
Sub:
Sub stream is a low resolution stream.
Codec:
Set the codec format for the particular stream.
Supported codec are MJPEG, H.264 and H.265.
Resolution:
Set the resolution for the particular stream.
Supported resolution caries as per the selected codec.
FPS:
Set the frame speed for particular stream. Frames per
second (fps) is same for both the streams. Supported FPS are
5, 10, 15, 30.
Bitrate:
Sets the maximum allowed bitrate for the particular
stream. Supported bitrate are 256, 512, 1024, 2048, 4096 and
6144 Kbps for H.264 and H.265 stream and 20, 40, 60 for
MJPEG stream.
Rotation:
Sets the video rotation of stream. Video Rotation
is same for both the streams. Supported video rotation are 0
degrees, 90 degrees, 180 degrees, 270 degrees.
Audio:
If audio is enabled for continuous/event recording
stream then audio data is also captured and stored with
video data.
Audio codec:
Supported audio codecs are ulaw and alaw
for camera and ulaw for Audio IO device.
Audio/Video Settings
(cont.)
Snapshot:
Streams configured as mjpeg can be used for
taking photos at regular intervals. To configure a stream
for mjpeg codec, select mjpeg in the dropdown menu for
Codec and enable the option for taking snaps.
Time Display:
If this option is enabled, then time stamp will
be displayed on the video data of the camera.
NTP:
If this option is enabled, then camera time will be
synced with the NTP server. NVR is NTP server.
Static IP:
If the checkbox is checked, device will be
considered as static device.
Static IP address:
Assign static IP address to the device.
Valid range for static ip is (182.168.1.100 to 182.168.1.149).
Populate Settings:
This feature allows users to populate
device settings to another or multiple devices. Configuration
of selected device from the first dropdown will be saved
devices from the second multi selection box. This will save
all camera configurations. Cameras will be reconfigured on
next boot.
ROADRECORDER 7000 NVR USER GUIDE
28