Safety Vision SAFESTOP-HD User Manual - Installation
3
Installation
Use the following procedure to install the SAFESTOP-HD.
Using the included template, tap or otherwise mark the
1.
screw holes and passage for the cables in the desired
mounting location.
Use self-tapping screws or rivets to secure the base
2.
plate to the desired mounting location.
Connect the cable assembly to the I/O Connector and
3.
LAN Ethernet ports.
Thread the cables through the base plate and drilled
4.
cable passage.
Insert the camera module into the unit casing, ensuring
5.
it is secure in the spring steel bracket, and secure it with
the two provided screws.
Place the unit casing with secured camera module onto
6.
the base plate.
Loosen the security screws on the camera gimbal to ad-
7.
just the camera angle to the desired field of view. This
might require the use of a PC connected to the Web
Interface (see the Web Interface chapter on page 5). Once
completed, tighten the security screws in place.
Place the dome cover over the base unit so that the
8.
view of the camera is not obstructed.
Place the weather shield over the dome cover and se-
9.
cure the entire assembly with the four included security
screws.
Connect to the Web Interface and perform the focusing
10.
procedure as described on page 8.
Consult the wiring schematic on the following page to
11.
complete the installation.