Saint ST 2004 User Manual - Security System Operation
SAINT
3
Security System Operation
Using the Transmitter to Arm the Security System
1. Exit the vehicle and close all entrances.
2. Press and release the ARM/Lock button on the transmitter. The security system will respond
as follows:
a. The siren will chirp one time.
b. The LED indicator will begin to flash at a steady rate.
c. The parking light will flash one time.
d. The starter disable relay is activated and will prevent the engine from starting.
e. All protected entrances are armed.
The Security System is now fully ARMED!
Automatic Arming
(Without using Transmitter)
NOTE : The following information is valid only if your security system has been programmed to
Automatically (Passive) arm. Check with your dealer if you are unsure.
Turn off the ignition key and exit the vehicle.
Close all protected entrances.
After the last protected entrance is closed the siren will chirp one
time and the LED indicator
will begin to flash rapidly. The fast flashing LED indicates that the
auto arm timer is counting
down and the security system will become armed within 30 seconds.
After 30 seconds has passed, the security system will respond as follows:
Note 1 : Reopening a protected entrance will stop the arming timer. After closing the entrance the
timer will begin counting down again from zero.
Note 2 : If the vehicle has a delayed interior lighting system, the auto arming timer will start
counting after the interior lighting has turned itself off. This could add up to 30 seconds
to the total auto arming countdown time. (Up to 60 seconds total arming delay)
A. The siren will chirp one time.
B. The LED indicator will begin to flash slower.
C. The parking lights will flash one time.
D. The starter disable relay is activated and will prevent the engine from starting.
E. All protected entrances are armed.
The Security System is now fully ARMED!