Salcom 12-86-9000 Product Manual - page 6
P a g e
| 5
12-86-9000 CALLPOINT TRANSMITTER
Product Manual
Sea Air and land Communications Ltd, 10 Vanadium Place, Addington, Christchurch 8024, New Zealand
April 2017
Programming
In order to program the12-86-5000, programming software should be downloaded from the
Salcom website (www.salcom.co.nz).
A Salcom 12-47 programming lead is required to program
the 12-86 transmitters (the same lead used to program the
11-85 transmitters). This may be purchased separately. The
12-47 programming lead requires the availability of a PC
with a serial port, running windows XP.
Connect the 12-47 as shown below, with the dot (circled in
yellow) on the 12-47 socket towards the centre of the PCB
(mating with the square pad).
The 12-86 Programming Software allows the transmitter frequency and button messages to be
set.
1. Press “Connect”. The red LED will light, as a message is transmitted. After the message
has been sent, the green LED above the 4th button will light for approximately 1 second.
The status at the bottom of the 12-86 PSD will indicate if successfully connected.
2. Press “Read”. The current configuration is read from the 12-86-5000.
3. Make any required changes.
4. Press the “Program” button.
5. Press “Disconnect”, then remove programming lead.