Salus SS881ZB Quick Install Manual - page 8
ϴ
ϭ͘ϯ
•
Pulling out the insulation tape can energize the Door/Window SENSOR to scan netwrok and
subsequently paired to the network successfully. The sensor will take below rules for its joining:
(a). It will scan all channels every 5 seconds and will try to join any available network. For each
scanning, the LED will blink for 3 times.
(b). If no network found after 20 times of scan, the Sensor will stop the trying to join. (LED will be in
constant off state.)
(c). After stop of scanning
, a single press on the tamper button or having a magnet triggering of the
sensor, or re-powering up of the sensor, can has the sensor resume the scanning state again.
ϭ͘ϰ
ǣ
•
Once paired successfully with below page, click on “CONTINUE WITH PAIRED DEVICE”; then
input the name,click”NEXT”.
•
It’s done with adding of a sensor now.