Salus SS881ZB Quick Install Manual - page 9
ϵ
ϭ͘ϱ
Ȁǣ
On the “Home” page, you can see all of your devices. Within the “Sensor” group, your sensors
were listed there. For example, along with the Window sensor magnet part close/ apart, it will show
the Closed/Open state on the list immediately, also with a historical log for the changes on right
side.
ϭ͘ϲ
ǣ
1) Redo a pairing for an already paired device:
a) A normal way of this is to remove the device from the “setting” page while the device is
online. If you did that with device offline, it would also take the leaving network process
once it’s back.
b) If your sensor was paired early to another iControl-hub, it would not take a pair process
automatically. You have to force it to leave the network and join again. You need to hold
the temper switch while the sensor was powering up by reinstalling the battery, the LED
will be lit and you shall release the switch within the first 4 seconds. The the sensor will
leave its past network and begin the pairing process as upper step 4.3, of cause, prior
with ready on the web page and the hub.
* With this operation, if the sensor was in fact in a same network early, the pairing will be
failed. You have to find out it from the device list and remove it and do that again.
2) Resume of the lost link state:
In case of lost link from network (can not find the parents node), the Sensor can try to rejoin the
network every 5 minutes, or by 5 times of press on the button, with less then 1.5 seconds for
each press.