Samlexpower PST-15S-12E Owner's manual - Section 1 |
2 | SAMLEX AMERICA INC.
SAMLEX AMERICA INC. | 3
seCtIOn 1 |
safety Instructions
1.1 iMPoRtAnt SAFetY inStRUctionS AnD SYMBoLS
SAVE THESE INSTrUCTIoNS. This manual contains important instructions for models
PST-300S-12E and PST-300S-24E that shall be followed during installation, operation and
maintenance.
The following safety symbols will be used in this manual to highlight safety
and information:
WARninG!
Indicates possibility of physical harm to the user in case of non-compliance.
!
cAUtion!
Indicates possibility of damage to the equipment in case of non-compliance.
i
inFo
Indicates useful supplemental information.
Please read these instructions before installing or operating the unit to prevent personal
injury or damage to the unit.
1.2 SAFetY inStRUctionS - GeneRAL
installation and wiring compliance
• Installation and wiring must comply with the Local and National Electrical Codes and
must be done by a certified electrician.
Preventing electrical shock
• Both the output sockets L1 and L2 of the Schuko Receptacle and both the output
terminal L1 and L2 for hardwiring are LIVE/HOT and are floating with respect to the
metal chassis Ground/Earth Ground (there is NO Neutral). Do not touch! Refer to Sec-
tion 8.5.1 for details.
• Always connect the grounding connection on the unit to the appropriate grounding
system.
• Disassembly / repair should be carried out by qualified personnel only.
• Disconnect all AC and DC side connections before working on any circuits associated
with the unit. Turning the ON/Off switch on the unit to off position may not entirely
remove dangerous voltages.
• Be careful when touching bare terminals of capacitors. Capacitors may retain high le-
thal voltages even after the power has been removed. Discharge the capacitors before
working on the circuits.