Samlexpower SI-A1-VR1500 Owner's Manual - Caution:

5.  Connect a length of wire between the inverter’s negative (-) terminal 

and the DC power source negative (-) terminal. 

6. Connect 

a 

short 

length 

of wire to the other terminal of the fuse holder 

or circuit breaker. Mark it “POSITIVE” or “+”. 

7.  Connect the free end of the fuse or breaker wire to the positive terminal 

of the DC power source (battery). 

8.  Insert a suitable fuse in the fuse holder. 

9.  Check to be sure that all connections between battery clips, terminals 

and fuse are secure and tight. 

10.  Test the inverter by turning it on and plugging in a 100 watt lamp or 

equipment. 

11. If the inverter is not properly operating, then refer to the 

troubleshooting sections of this manual. 

CAUTION:

  Loose connectors may cause overheated wires and 

melted insulation.   

CONNECTION TO LOAD 

The inverter is equipped with two universal AC power receptacles. Plug the 

cord from the equipment you wish to operate into the AC receptacle. The 

green LED indicator lights to indicate that the inverter is functioning. Make sure 

the combined load requirement of your equipment does not exceed inverter’s 

output rating. 

The inverter is engineered to be connected directly to standard electrical and 

electronic equipment in the manner described above. Do not connect the 

power inverter to household or RV AC distribution wiring. Do not connect the 

power inverter to any AC load circuit in which the neutral conductor is 

connected to ground (earth) or to the negative of the DC (battery) source. 

WARNING: Do not connect to AC distribution wiring. 

7